Micsig High Voltage Differential Probe DP750-100 with Micsig UPI

£147.28 (£176.74 inc VAT)

Available on back-order

Description


The leads and probe are with shielded design, interface ends are integrated in a compact box, no need to twist the cables, leads to a lower noise floor and has less interference. Support one-press Zero calibration and automatic overrange alarm. Directly powered by Micsig UPI interface, realise auto scaling setup, can also powered by oscilloscope via USB cable.

Applications include…

  • Floating measurements
  • Switch-mode power supply design
  • Motor drive design
  • Electronic ballast design
  • CRT display design
  • Power converter design and service
  • Power device evaluation

Features:

  • Test leads & probe with built-in shielding function
  • Support USB power supply, suitable for any brand of oscilloscope
  • Support direct power supply when connecting with Micsig UPI interface
  • Automatically match the attenuation ratio when using with Micsig latest Smart series oscilloscope
  • High accuracy, low noise, exquisite appearance

Product Videos

Documentation

DP750-100 Specifications
Model DP750-100
Bandwidth 100MHz
Rise Time 3.5ns
Attenuation 50X; 500X
Gain accuracy ±2%
Maximum Differential Test Voltage (DC+AC PK) 50X: 75V; 500X: 750V
Maximum input common mode voltage (DC+AC PK) CAT II 1000V
Input referred noise ≤3mVpp(50X)
≤ 3mVpp(500X)
Common Mode Rejection Ratio > 80dB (DC)
> 80dB (100KHz)
> 60dB (1MHz)
Input Impedance 8MΩ||1.25pF(differential)

4MΩII2.5pF (single end to ground)

Output Voltage ≤ 1.4V
Over range Alarm Button light flashes
Power Supply DC 5V,USB Supply
Power 1W
Dimension Power Supply Box: 80*37*22 mm Signal In/Output Box: 49*25*12.5 mm
Input cable length 150mm
Output cable length 1000mm

Note* Specifications are liable to change. For the full list of Specifications, please see the products datasheet located under the ‘Documentation’ tab.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.