PBZ Series: How to Output Synchronised Square Wave from TRIG OUT Terminal
To transmit a synchronised trigger pulse for output, you can create a trigger signal output (TRIG OUT): through the sequence function or with the following settings. When you output a square wave signal, it is easier to configure the following settings. The settings are available in a single operation only, not in a synchronized operation.
1. Output Example
PBZ outputs at 1 kHz.
2. Settings
Note: Set TRIG OUT to SYNC in the menu page 5/5. See the actual setting examples below:
*1: If SWEEP is set to OFF, set AC signal frequency in the FREQ setting.
*2: You can change the phase of output and trigger signal output (TRIG OUT) in the PHASE setting. *3: If TRIG OUT is set to SYNC, the square wave signal is outputted regardless of the SWEEP
setting.
Products Mentioned In This Article:
- PBZ Series please see HERE
